Supply lines, valves and leaks
Leak detection
Concealed leaks inside walls, beneath floors and in slab piping tracked down with moisture meters, thermal imaging and pressure tests before anything is opened.
- Phone answered every hour, holidays included
- Fault found and explained before anything is cut
- Moisture and thermal mapping
- Flow-tested in front of you when finished
Call now(365) 517-7215. A plumber picks up, day or night.
- Open 24/7. Phone answered every hour, holidays too.
- Licensed & insured. Trade licence details given on request.
- Shown before cut. You see the fault and the plan first.
- Gas by gas techs. Licensed gas technicians on gas heaters.
A damp patch overhead, or a meter dial creeping while every tap is shut, confirms water is escaping somewhere. Finding it without opening half the house is the skill.
The meter test
- We start at the water meter.
- With every fixture off, any movement on the meter dial shows water is leaving the system.
- Shutting branch valves in sequence pins down which part of the house is losing it.
Clues it is this job
- Ceiling stain under a bathroom
- Water meter moving with taps off
- Warm spot on a floor
- Musty smell in one room
Tools that see through walls
- Moisture meters, thermal cameras and acoustic listening help us map wet areas and follow them to the source.
- Waste-pipe leaks show themselves only while water is draining, so we operate each fixture one after another.
Opening the smallest hole
- Once we are confident of the location, we open a neat access hole, make the repair and leave a clean opening ready for patching.
A toilet flapper leak shows on the meter too. Rule it out first.
How the job runs, step by step
- 1Meter test
- 2Moisture and thermal mapping
- 3Source confirmed
- 4Small access opening and repair