Supply lines, valves and leaks
Pipe leak repair
Pinhole copper leaks, dripping threaded joints and failed push fittings repaired properly with soldered, pressed or crimped connections in Toronto homes.
- Phone answered every hour, holidays included
- Fault found and explained before anything is cut
- Leaking section cut out
- Flow-tested in front of you when finished
Call now(365) 517-7215. A plumber picks up, day or night.
- Open 24/7. Phone answered every hour, holidays too.
- Licensed & insured. Trade licence details given on request.
- Shown before cut. You see the fault and the plan first.
- Gas by gas techs. Licensed gas technicians on gas heaters.
A small leak rarely stays small. Pinholes in copper, weeping threaded joints in galvanized steel and loose compression fittings all get worse over time.
Pinholes in copper
- Pinholes often come from water chemistry or high velocity.
- We cut out the section and replace it, and if there are several pinholes in the same run we talk about replacing the run.
Clues it is this job
- Green or white crust on a copper joint
- Rust stain under a steel fitting
- Drip under a sink
- Damp drywall at floor level
Threaded steel joints
- Galvanized pipe rusts from the inside and leaks at the threads.
- We replace the section with copper or PEX and a proper transition fitting.
Fittings
- Compression nuts under sinks can loosen or crack.
- We replace them with new ferrules or modern fittings and check the shut-off valves while there.
Several pinholes in the same area often mean the whole run is wearing thin.
How the job runs, step by step
- 1Water off and line drained
- 2Leaking section cut out
- 3New pipe and fittings installed
- 4Pressure and leak test