Water heaters
Hot water heater fixes
Tank water heaters with no hot water, a pilot flame that keeps going out, leaking valves or rumbling sediment diagnosed and repaired across Toronto.
- Phone answered every hour, holidays included
- Fault found and explained before anything is cut
- Controls and sensors tested
- Flow-tested in front of you when finished
Call now(365) 517-7215. A plumber picks up, day or night.
- Open 24/7. Phone answered every hour, holidays too.
- Licensed & insured. Trade licence details given on request.
- Shown before cut. You see the fault and the plan first.
- Gas by gas techs. Licensed gas technicians on gas heaters.
When the hot water fails, the cause on a gas tank is often the pilot or thermocouple, and on an electric tank an element or thermostat. Leaks are a different story and need careful diagnosis.
Gas tanks
- We check the gas supply, the pilot, the thermocouple or flame sensor and the venting.
- Power-vented models add a blower and a pressure switch to the list of suspects.
- Plenty of Toronto households lease their tank, and we will say plainly when the rental provider ought to handle it.
Clues it is this job
- No hot water at any tap
- Hot water runs out quickly
- Water on the floor beside the tank
- Popping or rumbling while heating
Electric tanks
- Electric heaters have upper and lower elements and thermostats.
- We test each with a meter, replace the failed part, and check the reset button and wiring.
Leaks and noise
- Water dribbling from the T&P relief valve can signal high pressure or a faulty valve.
- A leak from the tank itself usually means replacement.
- Rumbling comes from sediment, which a flush can sometimes reduce.
If your heater has a rental sticker, check your agreement before paying for repairs.
How the job runs, step by step
- 1Fuel or power supply checked
- 2Controls and sensors tested
- 3Failed part replaced
- 4Temperature and venting checked