Skip to content
Toronto 24Hour Plumber
Close-up of a large rusty pipe with bolted fittings.

Supply lines, valves and leaks

Low water pressure repair

Feeble showers and slow tubs traced to clogged aerators, failing pressure regulators, half-closed valves or narrow old service pipes, then corrected.

  • Phone answered every hour, holidays included
  • Fault found and explained before anything is cut
  • Fixtures checked
  • Flow-tested in front of you when finished
Call now(365) 517-7215. A plumber picks up, day or night.

Weak flow can affect a single tap or every outlet at once. The cause dictates the fix.

One fixture

  • Aerators and showerheads clog with mineral scale from our moderately hard lake water, and a worn cartridge inside a single-handle faucet can choke flow to one fixture.
  • We unscrew, soak, brush and test each piece, and replace cartridges that are scored or swollen.

Clues it is this job

  • Weak shower
  • Pressure drops when another tap opens
  • Slow tub filling
  • Sputtering taps

Whole house

  • With the whole house weak, step one is making sure the main valve is wide open, because a gate valve with a broken wedge can look open while blocking half the pipe.
  • Then we put a gauge on a hose bib to read static pressure and inspect any pressure reducing valve fitted downstream of the meter.

Old pipe

  • Galvanized steel narrows from the inside as rust builds up, and many older Toronto houses still run on a half-inch service from the street.
  • When the pipe itself is the restriction, replacing the worst runs or the service line is the only change that brings real flow back.

A pressure gauge on the hose bib gives a reading in seconds.

How the job runs, step by step

  1. 1Static and flow pressure measured
  2. 2Fixtures checked
  3. 3Valves and regulator checked
  4. 4Cause repaired

Pipe split, drain rising, tank cold?

A Toronto plumber is on the line right now.

Call now(365) 517-7215.
Call a plumber now(365) 517-7215